Some simple tips on auto electrics

[zihadhosenjm40]

Automotive Electrics Basics for Beginners – Where to Look for Problems?
Auto electrics, one might say, rightfully occupy a leading position in the car, since many design elements belong to this category, so breakdowns in the system are quite common. Most often, they occur due to poor-quality contacts, in addition, the harnesses are subject to natural wear, as a result of which they fray. Often there are defects in sensors, which leads to their improper functioning.


Dust, dirt and moisture have a negative effect on mounting blocks, electrical circuits and bulbs. Often there are also "unsoldered" contacts. It is very important to monitor the condition of sensors, especially those rcs data for the correct operation of the motor.


After all, if they give incorrect readings, or do not give them at all, then the correct operation of the engine will be in doubt, which will lead to its rapid failure.

The “smarter” the control unit, the less we can help it in case of a breakdown, so periodically have this mechanism diagnosed at a service station.

The basics of auto electrics for beginners are not so complicated, knowing and adhering to them, you can not only identify the simplest faults, but also extend the life of some elements. So, if you need to replace fuses, then it is quite possible to do this using duplicates of exactly the same rating. A very common mistake is that when installing the battery, the poles are confused, so you need to be careful even with such a seemingly simple task. In order not to prematurely fail the generator, do not "light" the car when the temperature outside is below zero.

Always buy only high-quality parts, this is a guarantee of proper operation of both them individually and the entire system as a whole. For example, if you bought a thin wire and connected it to a powerful amplifier, it is quite possible that the first one will melt, and this will cause an unwanted short circuit. When installing fog lights, buy additional new fuses and relays.

Be sure to pay attention to the operation of the instrument panel, it should light up when starting. Then, when the engine is already running, there should be no indicators on it that signal any malfunctions.