It is necessary to make the canopy structure sufficiently rigid and light. To do this, three or four lathing bars must be sewn onto the rafter mini-supports. Ideally, you can make a canopy with a continuous sheathing of the slope with clapboard or lath. In this case, the slope can be made from the remains of soft roofing material, sheathed with metal tiles or slate.
After laying the flooring, it is necessary to protect paraguay mobile database area where the roofing material of the canopy adjoins the wall. The easiest way is to seal the joint between the metal and the wall material with a sealant or stick a tape of roofing felt. A narrow strip of metal cornice must be made and sewn on top of the sealed layer.
At the final stage, it will be necessary to cover the gable plane with clapboard or plastic panels. Experts recommend making the wall cladding with tenon boards or siding, located horizontally. In this case, the tenon on the outer surface should "look" down, otherwise moisture will easily flow into the joints.
For brick or frame buildings, the easiest way to make a canopy is on a cantilever structure made of metal profile. The height of the vertical posts must be made so that the angle of the canopy slope is at least 10-12 o . The upper part of the structure can be fixed to the wall plate, the lower support can be sealed into a groove cut in the brick wall.
If the pediment is completely laid out of brick, in this case, to attach the upper part of the frame in the brick wall, it is necessary to make a niche 1.5-2 cm deep. The upper support of the canopy structure will be fixed in the niche and covered with a decorative overlay sheet. The joint is sealed with a sealant. The lower supports of the canopy frame are placed in the cut grooves and fixed with anchor fasteners.
The efficiency of the canopy is determined, first of all, by its design and correct fastening to the gable wall. If the terrain and plantings around the building exclude strong gusts of wind, the canopy can be made of very modest dimensions, but on condition that the foundation blind area is equipped with an effective drainage system. This design option can work no worse than a full-size scheme.