Trimming with a grinding machine "Bulgarian"

[zihadhosenjm40]

Roll the roller once with even pressure.


Then press down on the handle of the cutter so that the two jaws press on different parts of the element and break it.


If you are cutting diagonally and the cut line goes through the corner, it is better to do the last step (splitting) manually. Take the cut tile with both hands symmetrically from the "scratched" line and with a light movement "drop" it on your knee (take care of yourself) - an even split will occur and the corner will not chip off.

If you need to cut a small strip (up to 2 cm), it is better to choose a grinder as a tool. It is better to choose a disk with a diamond coating.


Cutting with a glass cutter or other sharp tools
This method will appeal to those who need to cut a small senegal mobile database of floor tiles. Place it on a flat surface and draw a glass cutter (with a sharp drill edge or several times with a sharp knife) along the cutting line. Then place the element on a nail (drill, electrode) and gently press on different sides of the line and it will split into two necessary parts.


The following video shows how to cut tiles with a glass cutter, grinder and glass cutter (~ 3 minutes of video)




Step 8: Grouting
Follow our advice and you will easily cope with grouting.

Make sure the tile adhesive is completely dry. It is best to wait 24 hours to prevent shrinkage from causing the grout to crack.
Remove all possible debris from the seams and plastic crosses.