YouTube channel Clage Russia

[zihadhosenjm40]

Using the template from the kit, mark and drill holes for mounting the water heater. Insert dowels into them and securely fix the flow-through heater to the wall using screws. Check with a level that the device is installed horizontally and vertically.

In some models, you will first have to remove the front panel to install the water heater on the mounting plate. Once connected to the water supply and electricity, it will need to be replaced.

Like a boiler, a pressure flow water heater needs russia mobile database be supplied with cold water directly from the riser or any place in the apartment's wiring, and a flexible hose needs to be connected to the outlet to connect to the hot water line behind the DHW riser tap.

Install ball valves on the flow-through fittings to shut off the device if necessary. Seal the threads with FUM tape. Install tees on the cold and hot water pipes and connect their outlets to the corresponding taps on the water heater with flexible hoses.

YouTube channel Clage Russia

First of all, make sure that the power allocated to the apartment is sufficient for the operation of the selected water heater. It should be sufficient with a reserve, otherwise the machines will turn off when heating the water.

Due to their high power, pressure flow meters are usually connected not to a socket, but directly to the electrical panel via a residual current circuit breaker of the corresponding nominal current. In this case, a three-core cable with a cross-section of 4 or 6 mm² is used.

Close the tap on the hot water riser and open the shut-off valves on the water heater. Turn on the hot water at the nearest faucet and wait a few seconds until it flows steadily and without jerks.