Installing Master Flash near the ridge

[zihadhosenjm40]

The Master Flash seal consists of heat-resistant corrugated EPDM rubber and an aluminum base. Another advantage of the material is the ability to install on already installed pipes, which is very convenient in case of quick roof repairs (for example, when eliminating a leak or replacing roofing material).

Installation is as simple as the material itself.

Montage Master Flash

It is necessary to lubricate the junction of the Master Flash base with roofing sealant, and then fix the seal to the surface using roofing screws. However, as practice shows, after some time, the tightness of the joint begins to gradually deteriorate. First of all, this is due to the quality of the sealant and atmospheric phenomena (temperature changes, gusty wind, rain or snow can disrupt the tightness of the connection).

In order to maximally protect the roof from france mobile database in roofing units with a round pipe, it is recommended to partially “insert” the upper part of the penetration under the roofing material or ridge strip.

The arrangement scheme for such an abutment should ideally be determined when drawing up the project for the rafter system and roofing "pie". The fact is that some options involve the installation of individual parts of the structure before laying the roof covering.

In addition to the type of roofing chosen for covering the roof, when drawing up a project, one should also take into account the location of the chimney pipe, its shape, as well as the material from which it is made.

Professional builders usually recommend using only ready-made structures produced by roofing manufacturers to arrange abutments. However, many craftsmen prefer to make these parts themselves.