I mounted the lathing on the walls.

[zihadhosenjm40]

For it, I use wooden bars with a cross-section of 5 by 5 cm, pre-treated with an antiseptic composition and fire retardant. I took such a height of bars because my mineral mats have a thickness of 5 cm.

Installation of wooden lathing.

The lathing is fixed to the penofol using dowel nails. It is germany mobile database to drill a hole in the beam and the wall, then insert the fittings into this hole and hammer the core.

The distance between adjacent lathing elements should be made such that the insulation mat fits in there (most likely, yours will be like mine – 60 cm). You can make it half as small, but then you will have to cut the basalt insulation.

By the way, here you need to decide right away how you will fix the lining. My lamellas will be located horizontally, which means I put the bars vertically. You can do it the other way around, the essence of the process does not change from this.

Installed the lathing on the window and door openings. This is one of the most difficult stages of the work. It is necessary to attach the bars both inside the opening and at the junction of the opening and the main wall.
It is especially difficult to make the lathing around the window openings (in the photo it is covered with laid clapboard).

When installing all the elements of the lathing, pay special attention to the observance of verticals and horizontals. This directly affects how even the walls will be after finishing.

If you plan to finish not only the walls with clapboard, but also other surfaces (ceiling and floor), you also need to fix the lathing there. Moreover, it is necessary to install support joists on the floor with smaller intervals so that the floor covering does not sag under the load.

Installation of insulation