Having installed the bathtub on the supports and connected

[zihadhosenjm40]

Foaming a steel bowl
The most convenient way to blow foam into the bathtub is to turn it upside down. Before starting work, wipe the surface with a damp cloth or sponge. Spread the foam around the perimeter of the bowl, gradually covering areas of 0.5 square meters.

Using a special gun when applying foam, you can reduce the material consumption by up to one and a half times. With its help, it is convenient to regulate the amount of incoming foam and the degree of its expansion.

The space around the technological holes, 1.5-2 centimeters wide, is left untreated so that the siphon can be easily connected later.

Excess foam applied can be easily cambodia mobile database off when it hardens using a construction knife. When treating the bottom of the bathtub, the places of installation on brick racks should be left unfoamed. This is due to the fact that over time the foam may sag, and the bathtub will become less stable.

Sealing spatial gaps
the siphon and drain/overflow to it, we begin to process the spatial gaps.

To seal the resulting cracks and improve the adhesion of the bathtub sides to the cement mortar, the bricks are covered with rolled gerlen. The fabric layer included in the gerlen acts as a kind of compensator between the bathtub body and the cement mortar.

Such a separator is necessary in order to change the geometric parameters depending on temperature changes.

To eliminate air zones between surfaces and improve adhesion of materials, tile adhesive is applied to the interlayer in one layer. Small cracks are easiest to seal with liquid cement diluted with tile adhesive.